Hight Quality 3M Vehicle Wraps | Affordable Vinyl Wraps Store

Step 1: Clean your Rims

To ensure that the wrapping adheres properly, the surface where the vinyl is applied needs to be clean and completely dry.

Rub the rims with a soft, damp cloth dipped in water and mild detergent. Rub alcohol can be used to remove any stubborn stains. After rinsing, wipe the surface dry.

Step 2: Installing the Wrap

Use your fingers to secure the vinyl in place after peeling off the backing. Apply heat to the vinyl as you press it into place using a flat edge or squeegee. Start at the center, and move outward using medium pressure. Any bubbles should be pushed to the edge of the rim and blown out.(3M Vehicle Wraps)

Step 3: Seal and trim the vinyl edges

Press the edges firmly into the crevices once you've placed your wrapping. Trim any excess wrapping with a pair scissors. Step back and admire your new rims.

This video will give you more tips and information on how to wrap vinyl around wheels.

How to care for your 3M Vehicle Wrapsped wheels

3M Vehicle Wrapsping should not be left unattended. The wraps around your rims need to be maintained regularly, just like the rest of the vehicle. This will ensure that they last longer and maintain their vibrant colors. You can achieve this by doing the following:

Was your wrap frequently

It is essential to wash your car at least once per week, as the wheels are constantly exposed to many elements. Handwashing the wrap is important. Use mild soap, a soft cloth, or an automotive sponge. Rinse thoroughly and dry with a microfiber towel. Use a chamois towel to remove excess water prior to drying.(Bronze Vinyl Wraps)

Test any cleaning product you plan to use on vinyl first. This will ensure that it does not damage the wrapping.

Think twice about taking your car to a drive through car wash. Some brush car washes are too harsh on vinyl and can cause damage, peeling or lifted edges. Do not wash your car at a facility that uses brushes. Most vinyl-covered wheels should be fine with just water spray.

You should also avoid using high-pressure waterjets as they could damage the wrapping and remove it from the surface of the rim. If this happens, you will have unsightly rims. The vinyl will begin to peel and wear.